Lucent Technologies Release 8.2 Manual Do Utilizador
Configuration 2: R7r (+CMS) <—ethernet—> R7csi
3
C-LAN Administration
Administration for Network Connectivity
CID: 77730
555-233-504 — Issue 1 — April 2000
84
Switch 2 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network on the
Node Names screen. This screen is administered on Switch 2. A Node Names screen
must be administered on each switch in the network.
Node Names screen. This screen is administered on Switch 2. A Node Names screen
must be administered on each switch in the network.
The node names and IP addresses in a network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or a Lucent representative.
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or a Lucent representative.
Note:
Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.
node names for switches, routers, and CMS starting on page 2.
Begin
Steps
> Open Node Names form — enter
ch node-n
> Go to page 2
> Enter values.
> Submit the screen
End
change node names
Page 2 of 6
NODE NAMES
Name IP Address
Name IP Address
default_________
0__.0__.0__.0__
_______________
___.___.___.___
net-96
_ 192.168.1 _.96
_______________ ___.___.___.___
node-1
_ 192.168.1 _.124
_______________ ___.___.___.___
node-2___ 192.168.1 _.125
_______________ ___.___.___.___
node-4__________ 192.168.1 _.39_
_______________ ___.___.___.___
node-5__________ 192.168.1 _.51_
_______________ ___.___.___.___
Field
Conditions/Comments
Name:
Enter node names for the following 5 nodes:
•
net-96: the network address of the node-1 and node-2 subnet
(this is described in the IP-Route task)
(this is described in the IP-Route task)
•
node-1: C-LAN Ethernet port on Switch 1
•
node-2: CMS node (for consistency, use the host name of the
CMS computer assigned during the CMS setup procedure —
see CentreVu CMS Software Installation and Setup,
585-215-866)
CMS computer assigned during the CMS setup procedure —
see CentreVu CMS Software Installation and Setup,
585-215-866)
•
node-4: Interface on the router to the subnet of Switch 2.
•
node-5: C-LAN Ethernet port on Switch 2.
IP Address:
The unique IP addresses of the nodes named in the previous field.