Lucent Technologies Release 8.2 Manual Do Utilizador

Página de 524
Configuration 3: R8si<—x.25 —> R8r Gateway 
<—ethernet—> R8si 
101
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
3  
C-LAN Administration
Switch 1 Task — Assign Node Names
This task assigns node names and IP addresses to each node in the network. This 
screen is administered on Switch 1. A Node Names screen must be administered on 
each switch in the network.
node is defined as any of the following — a C-LAN port, a bridge or router, a CMS 
ethernet port, or an Intuity AUDIX or other MSA network interface card. The Audix 
and MSA node name and IP address must be entered on page 1 of the screen. The data 
for all other node types must be entered on pages 2–6.
The node names and IP addresses in any network should be assigned in a logical and 
consistent manner from the point of view of the whole network. These names and 
addresses should be assigned in the planning stages of the network and should be 
available from the customer system administrator or from a Lucent representative.
Note:
Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter 
node names for switches, routers, and CMS starting on page 2.
Begin
Steps
> Open Node Names form — enter  
ch node-n
> Go to page 2.
> Enter values.
> Submit the screen
End
change node-names
                                                                    Page 2 of 6
                                 NODE NAMES
   Name              IP Address 
Name                IP Address
default________
0__.0__.0__.0__ _______________
___.___.___.___
node-1
 __  192.168.10_.1__ 
_______________    ___.___.___.___
node-3___
 
192.168.10_.3__ 
_______________    ___.___.___.___
_____________ _  ___.___.___.___ 
_______________    ___.___.___.___
Field
Conditions/Comments
Name
Enter unique node names for the following 2 nodes:
C-LAN Ethernet port on Switch 1
C-LAN Ethernet port on Switch 3.
IP Address
The unique IP addresses of the nodes named in the previous 
field.