Lucent Technologies Release 8.2 Manual Do Utilizador
Configuration 5A: R8csi <—ppp—> R8r (one C-LAN)
<—ethernet—> R8si
<—ethernet—> R8si
149
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
3
C-LAN Administration
Switch 1 Task — Assign Link via ppp Data Module to Switch 2
This task administers a ppp data module on Switch 1 for the ppp connection to Switch
2. The data module associates a link number with a port address, extension number,
and node name for the C-LAN port used for this connection.
2. The data module associates a link number with a port address, extension number,
and node name for the C-LAN port used for this connection.
Begin
Steps
>
Open Data Module form — enter
ad da 2376
> Enter values
add data-module 2376
Page 1 of x
DATA MODULE
Page 1 of x
DATA MODULE
Data Extension: 2376
Name: _ppp on link 1 to node-2___ BCC: 2
Type: ppp
COS: 1
Port: 01c0815 COR:
1
Link: 1_
TN: 1
Enable Link? n
Node Name: node-1-ppp
_
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 8993020_________
Digits: 8993020_________
Node Name: node-2__________
CHAP? n
Field
Conditions/Comments
Type:
This indicates the data-module type for this connection.
Port:
In this example, the C-LAN circuit pack is in slot 01c08; the
ppp connection is through port 15.
ppp connection is through port 15.
Link:
The link number must be in the range 1 – 33 (for R8r), not
previously assigned on this switch.
previously assigned on this switch.
Enable Link?
If you need to add an IP route that uses this node as a gateway,
this field must be set to
this field must be set to
y
before adding the IP route. Otherwise
leave this field set to
n
until the link administration is complete;
that is, until after all data modules and the processor channels
are assigned, then set to
are assigned, then set to
y
.
Name:
Information-only; appears in list generated by the “list data
module” command.
module” command.
BCC:
Bearer Capability Class. This is a display-only field.
1 of 2