Lucent Technologies Release 8.2 Manual Do Utilizador
H.323 Trunk Administration
2
H.323 Trunks
Administration for Network Connectivity
CID: 77730
555-233-504 — Issue 1 — April 2000
48
Task 6 — Modify signaling group
This task modifies the signaling group form to add a trunk group number to the Trunk
Group for Channel Selection field.
Group for Channel Selection field.
Begin
Task 6 Steps
> Busy out the signaling group — enter
bu sig 3
> Open the Signaling Group form — enter
ch sig 3
> Enter values
> Submit the screen
> Release the signaling group — enter
rel sig 3
.
End
change signaling-group 3
Page 1 of 5
SIGNALING GROUP
Group Number: 3
Group Type: h.323
Max number of NCA TSC: 0
Max number of CA TSC: 0
Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 3
Supplementary Service Protocol: a
Max number of CA TSC: 0
Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 3
Supplementary Service Protocol: a
Near-end Node Name: clan-a1
Far-end Node Name: clan-b1
Near-end Listen Port: 1720 Far-end Listen Port: 1720
LRQ Required? n Calls Share IP Signaling Connection? n
Bypass If IP Threshold Exceeded? n
Field
Conditions/Comments
Trunk Group for Channel
Selection
Selection
Enter the trunk group number. If there is more than
one trunk group assigned to this signaling group, the
group entered in this field will be the one that can
accept incoming calls.
one trunk group assigned to this signaling group, the
group entered in this field will be the one that can
accept incoming calls.