Lucent Technologies Release 8.2 Manual Do Utilizador

Configuration 2: R7r (+CMS) <—ethernet—> R7csi

C-LAN Administration

Administration for Network Connectivity

CID: 77730

555-233-504 — Issue 1 — April 2000

Switch 1 Task — Assign Node Names

This task assigns node names and IP addresses to each node in the network. This
screen is administered on Switch 1. A Node Names screen must be administered on
each switch in the network.

The node names and IP addresses in any network should be assigned in a logical and
consistent manner from the point of view of the whole network. These names and
addresses should be assigned in the planning stages of the network and should be
available from the customer system administrator or a Lucent representative.

Note:

Enter node names for Intuity AUDIX and MSA adjuncts on page 1. Enter
node names for switches, routers, and CMS starting on page 2.

Begin

Steps

> Open Node Names form — enter

ch node-n

> Go to page 2

> Enter values.

> Submit the screen

End

change node names

Page 2 of 6

NODE NAMES

Name IP Address Name IP Address
default_________

0__.0__.0__.0__ _______________

___.___.___.___

node-1

__ 192.168.1 _.124

_______________ ___.___.___.___

node-2___ 192.168.1 _.125

_______________ ___.___.___.___

node-3__________ 192.168.1 _.97_

_______________ ___.___.___.___

node-5__________ 192.168.1 _.51_

_______________ ___.___.___.___

Field

Conditions/Comments

Name:

Enter node names for the following 4 nodes:

•

node-1: C-LAN Ethernet port on Switch 1

•

node-2: CMS node (for consistency, use the host name of the
CMS computer assigned during the CMS setup procedure —
see CentreVu CMS Software Installation and Setup,
585-215-866)

•

node-3: Interface on the router to the subnet of Switch 1.

•

node-5: C-LAN Ethernet port on Switch 2.

IP Address:

The unique IP addresses for the nodes named in the previous field.
See the description of the Subnet Mask field in the next task for
information on valid IP addresses.