IBM 000-8697 Manual Do Utilizador
3-18
IBM Informix OnLine Database Server Administrator’s Guide
Change Pathname of Logical Log Tape Device
Location of Logical Log Files
When OnLine disk space is initialized, the logical log files are located in the
root dbspace. You cannot control this.
root dbspace. You cannot control this.
After OnLine is initialized, you can improve performance by moving the
logical log files out of the root dbspace and onto one or more disks that are
not shared by active tables. This can reduce disk contention.
logical log files out of the root dbspace and onto one or more disks that are
not shared by active tables. This can reduce disk contention.
If you do not know where your logical log files currently reside, select the
Status menu, Logs option.
Status menu, Logs option.
If you decide to move the logical log files, refer to
.
Change Pathname of Logical Log Tape Device
The logical log tape device is specified as
LTAPEDEV
in the configuration file.
You can change the value of
LTAPEDEV
while OnLine is in online mode. The
change takes effect immediately.
Be prepared to create a level-0 archive immediately after you make the
change, unless you change the value to /dev/null.
change, unless you change the value to /dev/null.
You can establish the value of
LTAPEDEV
as a symbolic link, enabling you to
switch between more than one tape device without changing the pathname.
Important: Any time you change the physical characteristics of the tape device, you
must create a level-0 archive. Otherwise, you might be unable to restore the complete
set of tapes. OnLine cannot switch tape devices during a restore. OnLine will expect
all logical log backup tapes to have the same block size and tape size as were specified
at the time of the most recent level-0 archive.
must create a level-0 archive. Otherwise, you might be unable to restore the complete
set of tapes. OnLine cannot switch tape devices during a restore. OnLine will expect
all logical log backup tapes to have the same block size and tape size as were specified
at the time of the most recent level-0 archive.
If you change the pathname to /dev/null, the change proceeds more
smoothly if you make the change while OnLine is offline. If
smoothly if you make the change while OnLine is offline. If
LTAPEDEV
is set
to /dev/null, you can restore OnLine data only up to the point of your most-
recent archive. You cannot restore work done since then.
recent archive. You cannot restore work done since then.
The tape device specified by the pathname must perform a rewind before
opening and on closing.
opening and on closing.