Alcatel Carrier Internetworking Solutions 4324 Manual Do Utilizador

Part 031640-00

May 2005

Access Point Status LEDs

Each LED represents the status of APs connected to a specific port on the 
switch. During operation, the LEDs provide the following information:

The LED states in 

 are listed in order of precedence (highest to 

lowest). If more than one AP is connected to the port, the state with the 
highest precedence is displayed.

The RJ-45 female connector pin-outs are shown in 

:

B-2 FE Network Port Pin-outs

B-3 AP Status LED

Red (solid)

An AP on this port has failed (highest precedence).

Red (flashing) An air monitor on this port has detected an unsecured AP. 

The AP is attached to your network but is not listed in the 
switch security policies. If security policies are enabled, 
clients are not granted access to your network through the 
unsecured AP.

Green 
(flashing)

An air monitor on this port has detected interference. The 
interfering device (AP or other radio source) has been 
detected by your valid APs, but has no wired presence on 
your network.

Amber (solid)

Load balancing is enabled on this port or an AP has reached 
the maximum number of clients it is configured to support.

Green (solid)

All detected APs on this port are operating as expected.

Off

No AP is detected on the port (lowest precedence).

LNK/

ACT

POE

1
2
3
4
5
6
7
8

RJ-45 Female
Pin-Out

**Serial optional

*POE optional

Direction

Input

Output

10/100 Mbps

Ethernet

Serial TxD**   (POE positive*)
Serial TGND** (POE positive*)

Serial RxD**   (POE negative*)
Serial RGND** (POE negative*)

1
2
3
4
5
6
7
8

ETH Rx+  

(POE 

negative*)

ETH Rx–  

(POE 

negative*)

ETH Tx+  

(POE 

positive*)

ETH Tx–  

(POE 

positive*)