Lathem 7500E Manual Do Utilizador

22

Note: There are some environments and weather conditions that may influence the reception of the atomic 

clock radio signal.  Since it also operates as a highly-accurate (+/- 15 seconds per month) quartz 
time clock, the 7500E will function properly while outside the reception area or if it can not receive 

the WWVB signal.

Ensure the power cord is properly plugged into
the AC outlet.

1. Wait for the early morning hours to pass.
2. Re-locate in area that is away from metal studs
    or close to western facing window.

1. Ensure the correct time zone is selected.
2. Check the Daylight Savings Time setting.

What do I do if the clock does not operate?

What do I do if the clock does not print?

Ensure the ribbon is installed properly.

What do I do if no WWVB signal has been received?

What do I do if the time is exact to the minute but the
hour is incorrect?

Remove paper clips or "sticky notes" from 
inside clock.

1. Replace or reinstall ribbon.
2. Check print head.
3. Send to Lathem or authorized dealer for
    cleaning and service.

Send to Lathem or authorized dealer for service.

1. Make sure ribbon is installed properly.
2. Install new ribbon.

What do I do when the cards are sticking in clock?

What do I do when the clock rejects the cards
without printing?

1. Make sure bar code on cards are not smudged.
2. Removing anything that is blocking bar code
    sensor i.e.  Sticky pads, from time cards.

What do I do if clock makes a strange noise and
doesn’t print correctly?

What to do if print head is not moving at all?
Will not accept cards.

What to do if print head is moving but it prints very
lightly or not at all?