Bay Technical Associates DS Series Manual Do Utilizador

14 

NOTE: Depending on the DS-Series model, the menus may vary according to the number of DS74 
modules installed in the unit. If this is not an initial set-up and Password has already been enabled, you 
are prompted to login. After logging in successfully, invoke the main menu by sending the attention 
character five times (;;;;;). 
 
NOTE: Password feature is case sensitive. Default is ‘root/baytech’. 

 

 
IMPORTANT: The Factory default serial communications parameters are 9600 bps, 8 data 
bits, 1 stop bit, and no parity. 

  
With a proper connection to the unit upon power-up or unit reset, the following initialization and 
Status menu will be displayed except the number of outlets will be dependent on the specific DS unit: 

     
 

NOTE: Only the Administrator user will see the configuration option. 

 

IMPORTANT: If you get the following message after selecting the ‘Configure’ option, the 
other port has the configuration option selected. 

IMPORTANT: Once you make a change to any of the Configuration options, you have to 
back out of the Configuration menu and will be asked to ‘Accept’ changes. If you type ‘Y’ for 
YES and press <cr>, the changes take effect immediately for the serial port. For the Ethernet 
port you must do a Unit Reset to get the changes to take effect.