Bay Technical Associates DS Series Manual Do Utilizador

DS62-Network, DS62-MD4 Network/Modem Host Module

Enter the Selection number and the unit will display one of the following dependent on the alarm:

NOTE: M/P = Module number and Port number; Identifier = this unit’s model number; Tmp
Lvl = temperature level, Lo V Lvl = low voltage level, Hi V Lvl = High voltage level, low Curr
= Low Current. The unit’s firmware determines whether the degrees are Celsius or Fahrenheit.
Currently there is no option to change the degrees.

External Alarm Threshold

Selecting the Environmental Sensors with no probes attached the DS will display the following:

Selecting the Environmental Sensor with a probe attached the DS will display the following:

Select 1), the DS displays:

Selecting probe 2 displays a recognized temperature probe:

Sel M/P Identifier Low Curr
1 2/1 DS3ADE 0

Enter threshold value in tenths of unit measurement (degrees,%,etc.):

Enter voltage threshold value in tenths of a volt:

Enter low current threshold value in tenths of an amp:

None of the installed devices support this option (no temperature probes installed).

Strike ENTER to continue

Environmental Sensor Configuration Menu
Sel M/P Identifier
1 2/1 DS3ADE
2 All Sensors

Sel    Type             Name                    Hi/En    Lo/En   St/En
1   Contact           External Sensor1   N/A      N/A       Ds
2   Temperature  External Sensor2   0/Ds   0/Ds      N/A
Enter Request :2

DS/RPS External Environmental Sensor Configuration Menu
Sensor Number: 2   Name: External Sensor2 Type: Temperature

  1...High Threshold (tenths of meas. unit): 0
  2...High Threshold Trap Enable: Disabled
  3...Low Threshold (tenths of meas. unit): 0
  4...Low Threshold Trap Enable: Disabled

Enter Request :1