Sony 8000SF Manual Do Utilizador
470
Basic Procedure for DME Wipe Settings
Ch
For an overview of the DME wipe modifiers, see “DME Wipe Pattern
Variation and Modifiers” (page 80).
Variation and Modifiers” (page 80).
Specifying the DME wipe direction (Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the DME wipe direction in a menu
1
In the M/E-1 >DME Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
In the <Direction>group, specify the DME wipe direction.
Normal: regular direction
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
To specify the DME wipe direction with a button in the transition
control block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/Reverse
REV: Reverse
control block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/Reverse
REV: Reverse
Modifying the DME wipe pattern edge
1
In the M/E-1 >DME Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
the same time.
3
In the <Edge> group, select the edge type.
Border: border
Soft Border: soft border
Soft Border: soft border
4
Set the parameters according to the selection in step 3.