Avaya M-ACCF/SF Manual Do Utilizador

Chapter 3

Installation

Avaya M770 M-ACCF/SF ATM Access Modules User’s Guide

45

Setting up the M-ACC Module

Before you can set up the M-ACC module you must power on and set up the 
Avaya M770 switch as described in the Avaya M770 User Guide.
The following steps describe how to configure the M-ACC module using the 
Avaya M770 CLI.

To begin using the ATM access module you must first assign an IP address and 
ATM capabilities to the module via the CLI of the X-switch CPU.
You can either connect a VT-100 terminal or PC with VT-100 emulation to the Console 
port of the M-SPX/S Supervisor module or Telnet the M-SPX/S IP address.

To connect to the M-SPX/S Console port

1

Use the serial cable supplied to attach the RJ-45 console connector to the 
Console port of the M-SPX/S Supervisor module and the DB-9 connector to the 
serial (COM) port on your PC/terminal.

2

Ensure that the serial port settings on the PC are 9600 baud, 8 bits, 1 stop bit and 
no parity.

3

If you connected a PC, run a VT-100 emulation session. (You can use the 
Windows® HyperTerminal.)

4

After the M-ACC enters setup mode, you are prompted to enter a user name 
and password. Type the Login Name super and Password super and Enter 
(only if you are connected via Telnet).

5

The Switch Main Menu displays:

         Switch Main Menu

----------------------------------

     Select an Agent to configure:

<CR> Refresh the screen

0. Return to Previous Menu

1. Direct Access to specific module

2. M-SPX in slot: 15

   manages modules: 3,4,5,7,9,10,11

>>>Enter your choice

When you choose Option 1 and enter the M-ACC slot number, you reach the 
M-ACC’s Setup Main Menu.