Q-Logic 8C Manual Do Utilizador
59042-01 A
4-1
Section 4
Installation
This section describes how to install and configure the SANbox2-8c switch. It also
describes how to load new firmware and how to recover a disabled switch.
describes how to load new firmware and how to recover a disabled switch.
4.1
Site Requirements
The following items are required for the installation of a SANbox2-8c switch:
■
Fabric management workstation
■
Power requirements
■
Environmental conditions
4.1.1
Fabric Management Workstation
SANbox Manager requires a management workstation equipped as described in
:
Telnet workstations require an RJ-45 Ethernet port and an operating system with
a Telnet client.
a Telnet client.
4.1.2
Switch Power Requirements
Operating voltage requirements are as follows:
Table 4-1. Management Workstation Requirements
Operating System
■
Windows® NT, 2000, 95/98
■
Linux® 6.2 Red Hat®
■
Solaris™
Memory
128 MB or more
Disk Space
150 MB per installation
Processor
300 MHz or faster
Hardware
CD-ROM drive, RS-232 serial port, RJ-45 Ethernet port
Internet Browser
Microsoft® Internet Explorer® or Netscape Navigator®