DELL N3000 Manual Do Utilizador
1412
Managing IPv4 and IPv6 Multicast
Configuring and Viewing PIM-SM for IPv6 Multicast Routing
Beginning in Privileged EXEC mode, use the following commands to
configure PIM-SM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-SM information.
exit
Exit to Global Config mode.
exit
Exit to Privileged EXEC mode.
show ip pim
View system-wide PIM information.
show ip pim interface vlan
vlan-id
View the PIM information for the specified interface.
show ip pim neighbor
[interface vlan
vlan-id
| all]
View a summary or all the details of the multicast
table.
show ip pim rp-hash
groupaddr
View the RP router being selected for the specified
multicast group address from the set of active RP
routers. The RP router for the group is selected by
using a hash algorithm.
show ip pim bsr-router
[candidate | elected]
View the bootstrap router (BSR) information.
show ip pim rp mapping
View group-to-RP mappings of which the router is
aware (either configured or learned from the BSR)
Command
Purpose
configure
Enter global configuration mode.
ip routing
Enable IP routing. Routing is required for PIM
operation.
ipv6 unicast-routing
Enable IPv6 routing. IPv6 routing is required for IPv6
PIM.
ipv6 pim sparse
Enable PIM-SM as the multicast routing protocol on
the switch.
ip mld router
Enable MLD. MLD is required for the proper
operation of IPv6 PIM.
ip multicast
Enable IPv4/IPv6 multicast.
Command
Purpose