Q-Logic 16-Feb Manual Do Utilizador

Página de 196
B – Command Line Interface
Set Config Command
59021-06 A
B-29
D
Set Config Command
Sets switch, port, alarm threshold, and zoning configuration parameters.
Authority
Admin authority and a Config Edit session
Syntax
set config
port [port_number]
ports [port_number]
switch
threshold
zoning
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port 
number given by [port_number]. If you omit [port_number], the system begins with 
port 0 and proceeds in order through the last port. For each parameter, enter a 
new value or press the Enter key to accept the current value shown in brackets. 
Enter “q” to end the configuration for one port, or “qq” to end the configuration for 
all ports. 
 describes the port parameters.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all 
ports based on the configuration for the port given by [port_number]. If you omit 
[port_number], port 0 is used. For each parameter, enter a new value or press the 
Enter key to accept the current value shown in brackets. Enter “q” to end the 
configuration. 
 describes the port parameters.
Table B-9. Set Config Port Parameters 
Parameter
Description
AdminState
Port administrative state: online, offline, 
diagnostics, or down. The default is 
online.
LinkSpeed
Transmission speed: 1Gb/sec, 2 
Gb/sec, or Auto. The default is Auto.
PortType
Port mode: TL, GL, G, F, FL, Donor. The 
default is GL.
ISLSecurity
E_Port security. Determines which 
switches a port will establish a link with.
„
Any - link with any FC-SW-2 
compliant switch. This is the 
default.
„
Ours - link only with an FC-SW-2 
compliant QLogic switch.
„
None - reject the link.