Tektronix 2200 Manual Do Utilizador

4-17

5. Remove the nuts and lockwashers and disconnect the heavy red and 

black cables from the studs. If this is the upper supply in a redundant 
system, remove the extension studs and the second set of heavy cables 
from this supply as well.

6. Disconnect the small multi-wire connector from the top of the circuit 

board in the left compartment of the power supply frame and feed it 
back through the holes into the +5 Volt supply compartment.

7. At the right side of the compartment, on the rear of the +5 Volt supply, 

remove the terminal block cover (if present) and disconnect the blue 
and brown AC power wires from the terminal block. The green/yellow 
wire may be left in place.

8. Open the door at the front of the power supply frame. 

9. Remove the two screws at the bottom that secure the +5 Volt supply 

assembly to the power supply frame.

10. Slide the supply assembly forward out of the frame, taking care that the 

wiring follows freely.

(For Upper Supply in

Redundant

Power System

also Remove

Intermediate Studs

and Wires)

Disconnect

Connector from

Circuit Board

Remove Nuts

and Wires

from Studs

Disconnect

Blue and

Brown Wires

0347-0419

Black

Black

Red

Red

Feed Cable and

Connector through

Hole in Frame