Tektronix 2200 Manual Do Utilizador

4-36

If, after installing a software update, your floppy disk drive does not 
respond, you need to drain the Control Processor RAM on the two Control 
Processor modules. Follow the procedure listed below:

1. Remove the Control Processor I module located in the Switcher 

Processor Frame Slot A1 in the Model 2200 frame.

2. Remove the jumper located near the Lithium battery. 

3. Wait 15 minutes for the dielectric-capacitors to discharge. Or, to 

expedite the discharge process, connect the left jumper-pin to the 
nearest ground. This action drains the capacitor’s charge immediately.

4. Replace the Control Processor module into the Processor Frame.

5. Then remove the Control Processor II module located in slot A2 in the 

Switcher Processor Frame. 

6. Remove the jumper across J9. Jumper J9 is located near the Lithium 

battery. 

7. Wait 15 minutes for the dielectric-capacitors to discharge. Or, to 

expedite the discharge process, connect the right jumper-pin to the 
nearest ground. This action drains the capacitor’s charge immediately.

8. Replace the Control Processor II module into the Processor Frame.

9. Replace the Control Processor module(s) and return power to the 

frame.