Tektronix 2200 Manual Do Utilizador

2-25

There are two types of modules. The first type is a full sized circuit board 
that slides into the frame bays like a standard module. The second module 
type is a smaller “mezzanine” which mounts on a standard circuit board in 
the frame.

The installation for each of the Model 2200 options is described below. 
Options ordered with the system may already be installed. Most options 
also require configuration and/or setup using the soft panel menus. The 
menus are given at the end of this section along with explanations for using 
each menu.

Empty module cells in the rear bay have blank metal strips screwed in 
place to maintain proper air flow inside the switcher and to prevent 
electromagnetic interference. These must be removed before the options 
can be installed. 

Special EMI fingers are installed on each module connector and blank strip in rear 
bays. Use extreme care when removing or installing the modules and blank strips 
so that the EMI fingers do not break off.