Tektronix 2200 Manual Do Utilizador

2-48

The Status Terminal connector on the rear of the control panel allows the 
connection of a VT-100 (type) terminal to be connected to the Model 2200. 
The terminal is used to monitor system status and for maintenance 
purposes.

1. Connect a cable between the input of a VT-100 (type) terminal and J3 

(Status Terminal connector) on the rear of the control panel. The 
connector (J3) on the rear of the control panel is a standard RS-232 
configuration via a DB-25 connector with the following pin-outs:

■

 — Protective Ground

■

— TxD (From the Terminal)

■

 — RxD (To the Terminal)

■

 — Signal Ground

2. Ensure that the baud rate and other parameters of the Model 2200 given 

below match the baud rate of the terminal. See the Owner’s Manual of 
the terminal in use to determine or set the baud rate of the terminal. 
Also be sure the terminal is set to “Newline Off” or “No Newline”.

■

9600 baud 

■

8 data bits 

■

1 stop bit 

■

No parity 

Connect an analog signal such as color black or any other stable analog 
signal to either J5 or J6, ANALOG REF IN, on the Com I/O Module in Slot 
C10. Terminate any unused BNC connectors.