Tektronix 2200 Manual Do Utilizador

2-71

1. Open the control panel lid and check to see that the power switch 

(located on the left side of the tub) is in the OFF position.

2. Connect the power cable from the back of the control panel to source 

power. Do NOT turn control panel power on at this time.

3. Verify you have received the correct power cable. For use in Europe, 

the power cables must be TUV approved. The control panel power 
cable should be a molded grounding connector (IEC 320-C13) on one 
end with pigtails on the other. 

4. For use in the United States, Canada, South America and Southeast 

Asia, a standard 110VAC power cable is supplied for the control panel. 
It has a molded grounding plug (NEMA 5-15P) at one end and a 
molded grounding connector (IEC 320-C13) at the other end.

1. Ensure that the power switch located on the front of the switcher power 

supply is in the OFF position.

2. Connect the power cable from the rear of the switcher power supply to 

 for power requirements.

3. Make sure you have the correct power cable. For use in Europe you 

should have received a power cable with pigtails on the free end. For 
use in the U.S., Canada, South America and Southeast Asia the power 
cable should have a 20 Amp Twist-Lock 240 VAC NEMA Type l6-20P 
plug attached.

4. If a redundant switcher power supply is installed, connect it to a 

separate 220 VAC power source (branch circuit).