Toshiba PROA500 Manual Do Utilizador

 

 

31

 

The Bluetooth antenna wire, Bluetooth module or system board may be the reason of a 

Bluetooth fault. Any of these components may be damaged. To determine if the computer’s 

Bluetooth is functioning properly, perform the following procedures. Figure 2-16 outlines the 

process. Start with Procedure 1 and continue with the other procedures as instructed. 

Procedure 1:  Diagnostic test 

Procedure 2:  Connector and replacement check 

Run the Diagnostic Program, which will automatically execute the Bluetooth test.  Refer to 
Chapter 3 item A: “CONFIG CHECK TEST”, Tests and Diagnostics for more information on 
the program. 

If an error is located, go to Procedure 2.  If an error is not located, the Bluetooth system is 
functioning properly. 

 

The Bluetooth, antenna module or system board may be disconnected or damaged.  
Disassemble the computer following the steps described in Chapter 4, Replacement 
Procedures, and perform the following checks. 

 

Check 1 

Make sure the Bluetooth cable is securely slotted into the system board. If the 
problem persists, go to Check 2. 

Check 2 

Check the wireless communication function is enabled by BIOS setup or FN+F8, 
then make sure that the communication LED on the left panel is lit. If the problem 
persists, or if the Bluetooth communication LED is not lit when the wireless 
communication function is enabled by BIOS setup or FN+F8 to “On”, go to 
Check 3. 

Check 3 

The Bluetooth module may be damaged. Replace it with a new one following the 
instructions in Chapter 4. If the problem still exists, perform Check 4. 

Check 4 

The system board may be damaged.  Replace it with a new one following the 
instructions in Chapter 4.