Sony UP20 Manual Do Utilizador

Pre

par

at

ion

Connections

10

To enable printing, video equipment to act as an input 
signal source, and a video monitor to display images or 
menus must be connected.
The following diagrams illustrate how to make the input, 
output and remote control connections. Use this as a 
guide when connecting the cables required to transmit 
signals to and from the equipment to be used for 
printing.

• Turn off the power of each device before attempting to 

make any connections.

• Connect the AC power cord last.

Connect the video equipment providing the video 
images to be printed.
Connect the video equipment which will be used in 
actual printing, using the following diagram as a guide.
Before connecting the video equipment, see “Important 
safeguards/notices for use in the medical environments” 
on page 2.

Video equipment

to RGB

output

connectors

to composite 
video output 
connector

to S VIDEO

output

connector

75-ohm 
coaxial cable 
with BNC 
connectors

75-ohm

coaxial cable

with BNC

connectors

Connecting 
cable (with 
DIN 4-pin 
connectors)

to RGB SYNC 

b)

 

INPUT

to S

VIDEO

INPUT

to VIDEO 
INPUT

to AC IN

AC power cord

(supplied)

to wall outlet

NTSC/PAL selector 

a)

a) Set the NTSC/PAL selector to match your TV system. To 

switch the TV system, turn the power off once, then change 
the setting. If you change the setting with the power on, this 
mode will not be switched.

b) Only for the UP-21MD.

UP-21MD