Ricoh AP610N Manual Do Utilizador
Paper and Other Media
20
1
Specifying standard size paper for the
Bypass Tray
Bypass Tray
Important
❒ Shuffle the paper before loading
the stack onto the tray, so multiple
sheets are not fed in together.
sheets are not fed in together.
❒ Set the size and direction of the
loaded paper on the control panel
or with the printer driver. Make
sure the settings do not conflict.
Otherwise, the paper may jam or
the print quality may be affected.
or with the printer driver. Make
sure the settings do not conflict.
Otherwise, the paper may jam or
the print quality may be affected.
A
Slide the side guides outward,
and load paper until it stops with
the print side up.
and load paper until it stops with
the print side up.
Note
❒ If you load A4K or larger, or
8
1
/
2
× 11 Kor larger, slide out
the bypass tray extension ( )
and then flip it open ( ).
and then flip it open ( ).
B
Adjust the side guides to the pa-
per width.
per width.
Important
❒ Confirm that paper fits under
the side guides.
❒ Sheets of A4K or 8
1
/
2
x 11K
length or longer must be loaded
one at a time. Support the paper
by hand so it feeds in properly.
Additionally, since paper feed-
ing and image quality may dif-
f e r d e p e n d i n g o n p a p e r
thickness and width, check
print results in advance using
paper you intend to print on.
one at a time. Support the paper
by hand so it feeds in properly.
Additionally, since paper feed-
ing and image quality may dif-
f e r d e p e n d i n g o n p a p e r
thickness and width, check
print results in advance using
paper you intend to print on.
Note
❒ 45 kg paper or paper of A4K or
8
1
/
2
x 11 K or longer may not
feed in properly unless it is cut
at right angles.
at right angles.
C
To set the paper size and feed di-
rection, Press the {Menu} key.
rection, Press the {Menu} key.
The [Menu] screen appears on the
display.
display.
ZKGY200E
AGN028S
ZKGY220E
AGN503S
KirP4GB_Mainte-F6_FM_forPaper.book Page 20 Thursday, May 12, 2005 11:48 AM