Canon 7490 Manual Do Utilizador

 

3.  When communication is established correctly, the word "PASSWORD:" appears on the 

window. Type the login password (Network PIN code

*2

) for the projector and then press 

"Enter" key on the keyboard. If you do not set up the Network PIN code, just press "Enter" 
key.
When the word "Hello" is replied, login has been succeeded.

* The password "1234" is used for the example.

 

4.  Type the commands, refer to below table, to control the projector and then press "Enter" 

key for termination. For example, type "C00" which is a command to turn on the projec-
tor, and press "Enter" key. Confirm the projector is turning on.

* 

Enter with ASCII 64-byte capital characters and one-byte characters. 

To disconnect the communication, press "Ctrl" key and "]" key at the same time, type 
"close" and then press "Enter" key on the Keyboard.
 

> close [return]

The table below shows the typical command lists for controlling this projector and please 
consult your local dealer for further information of another commands.

*1  Further instructions about the telnet application, please see the on-line guide on your computer.

*2  The password is a Network PIN code decided item "Network PIN code setting" (

+

pp.14, 23). If the 

authentication of the entered password is failed 4 times continuously, the communication will be 

disconnected automatically. Please try again for the connection.

✐

  If the password or any command is not entered for more than 30 seconds, the communication will 

be disconnected automatically. Please try again for the connection.

Command    Function
  C00 

 Power on

  C02 

Power off

  C09 

Volume up

  C0A 

Volume down

  C0B 

Audio Mute on

  C0C 

Audio Mute off

  C1C 

Menu display on

  C1D 

Menu display off