ZyXEL Communications wireless n gigbit router zyxel Manual Do Utilizador
Chapter 13 Firewall
NBG-460N User’s Guide
182
13.4 General Firewall Screen
Use this screen to enable or disable the NBG-460N’s firewall, and set up firewall
logs. Click Security > Firewall to open the General screen.
logs. Click Security > Firewall to open the General screen.
Figure 123 Security > Firewall > General
The following table describes the labels in this screen.
13.5 Services Screen
If an outside user attempts to probe an unsupported port on your NBG-460N, an
ICMP response packet is automatically returned. This allows the outside user to
know the NBG-460N exists. Use this screen to prevent the ICMP response packet
from being sent. This keeps outsiders from discovering your NBG-460N when
unsupported ports are probed.
ICMP response packet is automatically returned. This allows the outside user to
know the NBG-460N exists. Use this screen to prevent the ICMP response packet
from being sent. This keeps outsiders from discovering your NBG-460N when
unsupported ports are probed.
Table 62 Security > Firewall > General
LABEL
DESCRIPTION
Enable Firewall
Select this check box to activate the firewall. The NBG-460N performs
access control and protects against Denial of Service (DoS) attacks
when the firewall is activated.
access control and protects against Denial of Service (DoS) attacks
when the firewall is activated.
Packet Direction This is the direction of travel of packets.
Firewall rules are grouped based on the direction of travel of packets to
which they apply.
which they apply.
Log
Select whether to create a log for packets that are traveling in the
selected direction when the packets are blocked (Log All) or forwarded
(Log Forward). Or select Not Log to not log any records.
selected direction when the packets are blocked (Log All) or forwarded
(Log Forward). Or select Not Log to not log any records.
To log packets related to firewall rules, make sure that Access Control
under Log is selected in the Logs > Log Settings screen.
under Log is selected in the Logs > Log Settings screen.
Apply
Click Apply to save the settings.
Reset
Click Reset to start configuring this screen again.