ZyXEL Communications wireless n gigbit router zyxel Manual Do Utilizador

 Chapter 6 AP Mode

NBG-460N User’s Guide

The following table describes the labels in this screen.

The table below describes the labels in the screen.

The configuration of wireless and maintenance settings in AP Mode is the same 
as for Router Mode.

• See 

 for information on the configuring your wireless 

network.

Table 27   Network > LAN > IP  

Get from 
DHCP Server

Select this option to allow the NBG-460N to obtain an IP address from a 
DHCP server on the network. You must connect the WAN port to a device 
with a DHCP server enabled (such as a router or gateway). Without a 
DHCP server the NBG-460N will have no IP address. You need to find out 
the IP address the DHCP server assigns to the NBG-460N and use that 
address to log in to the NBG-460N again. 

User Defined 
LAN IP 

Select this option to set the NBG-460N’s IP address. This setting is 
selected by default. Check the IP address is on the same domain as other 
devices on your network.

IP Address

Type the IP address in dotted decimal notation. The default setting is 
192.168.1.1. If you change the IP address you will have to log in again 
with the new IP address.   

IP Subnet 
Mask

The subnet mask specifies the network number portion of an IP address. 
Your NBG-460N will automatically calculate the subnet mask based on the 
IP address that you assign. Unless you are implementing subnetting, use 
the subnet mask computed by the NBG-460N.

Gateway IP 
Address

Type the IP address of the gateway. The gateway is an immediate 
neighbor of your NBG-460N that will forward the packet to the destination. 
In AP Mode, the gateway must be a router on the same segment as your 
NBG-460N.

DNS Servers
First DNS 
Server

Second DNS 
Server

Third DNS 
Server 

Select From ISP if your ISP dynamically assigns DNS server information. 
The field to the right displays the (read-only) DNS server IP address that 
the ISP assigns.

Select User-Defined if you have the IP address of a DNS server. Enter 
the DNS server's IP address in the field to the right. If you chose User-
Defined, but leave the IP address set to 0.0.0.0, User-Defined changes 
to None after you click Apply. If you set a second choice to User-
Defined, and enter the same IP address, the second User-Defined 
changes to None after you click Apply. 

Select None if you do not want to configure DNS servers. If you do not 
configure a DNS server, you must know the IP address of a computer in 
order to access it.

Apply

Click Apply to save your changes to the NBG-460N.

Reset

Click Reset to reload the previous configuration for this screen.