IBM 09-0572-000 Manual Do Utilizador
Using IBM Drivers
5-11
Enabling RPL
The following instructions explain how to use the RPL
program when your PC has both a hard disk drive and a
floppy disk drive. Refer to your network operating system
documentation for the steps to be performed on the
network to use RPL and for information on different drivers
that you can load with RPL.
program when your PC has both a hard disk drive and a
floppy disk drive. Refer to your network operating system
documentation for the steps to be performed on the
network to use RPL and for information on different drivers
that you can load with RPL.
To enable RPL:
1 Boot your PC under DOS.
2 Make sure that the backup copy of the
TokenDisk diskette
is in a floppy drive on your PC.
3 At the diskette prompt, type:
3TOKDIAG [Enter]
4 From the Install pull-down menu, select Configure Adapter.
5 Using the arrow keys, move to Boot PROM.
6 Press [Enter] and select Enable.
7 Press [Enter].
8 Select OK and press [Enter] to save the setting.
9 Remove the diskette from the drive and reboot the PC.
The following message appears at the top of your screen:
Type H to boot from the hard disk
10 Type
H
to boot from your local hard disk, or press any key
to boot from the network server.