Renesas M16C/6N5 Manual Do Utilizador
M306NKT-EPB User’s Manual
4. Hardware Specifications
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006
Page 91 of 104
4.6 Notes on Using This Product
Notes on using this product are listed below. When debugging the MCU using he emulator, be careful about the following
precautions.
precautions.
IMPORTANT
Note on the Version of the Emulator Debugger:
z
Be sure to use this product with one of the following emulator debuggers.
1. M16C R8C PC7501 Emulator debugger V.1.01 Release 00 or later
2. M3T-PD30F V.2.20 Release 1 or later
2. M3T-PD30F V.2.20 Release 1 or later
Note on Selecting the MCU File:
z
Select the MCU file “M16C6NK.mcu” at the startup of the emulator debugger.
Note on Malfunctions in the PC7501 System:
z
If the emulator malfunctions because of interference like external noise, do the following to remedy the trouble
(1) Press the RESET switch on the emulator front panel.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then reactivate it.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then reactivate it.
Notes on Downloading Firmware:
z
Before using this product for the first time, it is necessary to download the dedicated firmware (emulator’s
control software installed in the flash memory in the PC7501). Please note that, to do this, it is necessary to start
up the emulator main unit in maintenance mode. For downloading firmware, see "2.7 Downloading Firmware"
(page 28). Once the firmware has been downloaded, the product can be used by simply turning on the power.
up the emulator main unit in maintenance mode. For downloading firmware, see "2.7 Downloading Firmware"
(page 28). Once the firmware has been downloaded, the product can be used by simply turning on the power.
z
Do not shut off the power while downloading the firmware. If this happens, the product will not start up
properly. If the power is shut off unexpectedly, redownload the firmware.
z
Download the firmware with the user system not connected.
Notes on Self-check:
z
If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.
Then contact your local distributor.
z
Run the self-check with the user system not connected.
Note on Quitting the Emulator Debugger:
z
To restart the emulator debugger, always shut power to the PC7501 off once and then on again.