RAD Data comm IPmux-11 Manual Do Utilizador
Installation and Operation Manual
Chapter 4 Configuration
IPmux-11 Ver. 2.00
Configuring IPmux-11 for Operation
4-25
2. From the Bridge menu, select Aging time and define a period of time in
seconds from the moment when a node is disconnected from the network
segment or becomes inactive and removal of the node address from the
database.
segment or becomes inactive and removal of the node address from the
database.
3. Select Erase MAC table, if you intend to delete all learned addresses from the
MAC table.
4. Select Bridge policy, and from the Bridge Policy menu (
) define the
following:
VLAN tagging (operation mode for the corresponding port of internal
switch):
switch):
Transparent
Tag (Tagged)
Untag (Untagged)
DoubleTag (Double Tagged)
Default VLAN ID (VLAN associated with untagged frames arriving at the
port): 1–4095
port): 1–4095
Default VLAN Priority: 0–7
Rate limit:
User port: Disable, 256 kbps, 512 kbps, 1 Mbps, 2 Mbps, 4 Mbps,
8 Mbps, 16 Mbps, 32 Mbps, 64 Mbps
8 Mbps, 16 Mbps, 32 Mbps, 64 Mbps
Network port: Disable, 256 kbps, 512 kbps, 1 Mbps, 2 Mbps, 4 Mbps, 5
Mbps, 8 Mbps, 10 Mbps, 16 Mbps, 20 Mbps, 25 Mbps, 40 Mbps, 50
Mbps, 80 Mbps
Mbps, 8 Mbps, 10 Mbps, 16 Mbps, 20 Mbps, 25 Mbps, 40 Mbps, 50
Mbps, 80 Mbps
Selected rate limiting value for the user port changes available default VLAN priority
options for this port in the following manner:
Rate Limiting
options for this port in the following manner:
Rate Limiting
Default VLAN Priority
0–8 Mbps
0–7
16 Mbps
0–7
32 Mbps
2–7
64 Mbps*
4–7
* – Since the user traffic entering the switch via ports with 64 Mbps rate limiting
receives high priority, it may interfere with TDM traffic, which has high priority
by default.
by default.
5. Select VLAN table, and from the VLAN Table menu (
) configure the
following:
Channel:
Network-Eth1
User1-Eth2
User2-Eth3
VLAN ID (Specifies VLAN, which the current bridge port will be a member
of): 1–4095
of): 1–4095
Note