Nortel Networks 8683POS Manual Do Utilizador
68
Chapter 4 Managing the Passport 8683POS Module
209564-A
3
To configure IP routing, enter:
config pos <ports>> ppp ip-admin-status open
4
To configure an IP address on the selected port on both Passport 8683POS
Modules, enter:
Modules, enter:
config pos <ports> ip create <ipaddr/mask> <vid>
5
To enable the selected port on both Passport 8683POS Modules, enter:
config pos <ports> state enable
See
for descriptions of the CLI
commands.
Configuring IPX routing using Device Manager
When you use IPXCP encapsulation, you must select Ethernet II as the MAC
encapsulation for the protocol-based VLANs. IPXCP supports only the Ethernet
II format.
encapsulation for the protocol-based VLANs. IPXCP supports only the Ethernet
II format.
To configure the Passport 8683POS Modules for IPX routing using Device
Manager:
Manager:
1
Configure an Ethernet II protocol-based VLAN.
1
Highlight the port.
2
Choose Edit > port.
The Port dialog box opens with the Interface tab displayed (
).
Refer to Reference for Passport 8000 Series Management Software Routing
Operations for information on how to configure VLANs using Device
Manager.
Operations for information on how to configure VLANs using Device
Manager.
3
Disable the port as described in
.
4
To configure the VLAN as an IPX protocol-based VLAN and assign the port
to the VLAN:
to the VLAN:
a
From the Device Manager menu bar, choose VLAN > VLAN.