Avaya S8500 Manual Do Utilizador

Note:

If you pass the letter or number that you want, you have two options. You can 
cycle through all the letters or numbers to get to the one you want. Or, you can 
reinsert, or reseat, the circuit pack and start again.

Note:

If you have only one system, the default switch ID is A. The second system is B 
and so on. The switch ID is not the media gateway or carrier letter.

3. While the display characters are flashing, press the button until the switch ID, A through J, 

shows on the top character of the LED display. When the correct letter shows, stop. The 
letter flashes a few times, or 5 seconds, then stops. The next character down starts to 
flash. This is the first digit of the cabinet number.

Note:

The number to program is the cabinet number, not the port network number. If 
you have more than one IPSI in a cabinet, they all have the same cabinet 
number.

4. While the first digit of the number is flashing, press the button until the correct tens digit, 0 

through 6, for the cabinet number shows on the display. When the correct digit appears, 
stop. The digit flashes for about 5 seconds, then stops. Then the second digit starts 
flashing. 

5. While the second digit is flashing, press the button until the correct units digit, 0 through 9, 

for the cabinet number shows on the display. When the correct digit shows, stop. The digit 
flashes for about 5 seconds, then stops.