ZyXEL Communications n/a Manual Do Utilizador

 Chapter 20 VoIP Commands

DSL & IAD CLI Reference Guide

This example sets all telephones connected to the ZyXEL Device to receive calls via the PSTN 
line.   

Use these commands to configure call-forwarding rules on the ZyXEL Device.

voice config fxo fxoflashmin <index> 

<flash-min-interval> 

Sets the fxo flash key min interval value (miliseconds). 
The flash key being pressed is only recognized by the 
ZyXEL Device if it is pressed for a longer period than the 
flash key min interval but a shorter period than the flash 
key max interval.

voice config fxo fxoflashmax <index> 

<flash-max-interval>

Sets the fxo flash key max interval value (miliseconds). 
The flash key being pressed is only recognized by the 
ZyXEL Device if it is pressed for a longer period than the 
flash key min interval but a shorter period than the flash 
key max interval.

voice config fxo fxophselect <index> 

<phone-port|0:All><0:No|1:Yes> 

Specifies which telephones should receive calls via the 
PSTN line.

voice config fxo save <index> 

Saves the PSTN line configuration entry in the working 
buffer to non-volatile memory. 
The working buffer is a volatile memory space. The 
settings in the working buffer are not applied to the 
ZyXEL Device until you execute this command.

voice config fxo display 

Displays the saved values for the PSTN line 
configuration entry. 

voice config fxo dumpCfg 

Displays the configured values in the working buffer for 
the specified configuration.

Table 55   PSTN Line Command Summary

ras> voice config fxo index 1 

ras> voice config fxo fxophselect 1 0 1 

ras> voice config fxo save 1

Table 56   Call-forwarding Command Summary

voice config forward index <index> 

Specifies the call-forwarding table you want to configure. 

voice config forward unconditional <index> 

<phone-number> 

Specifies the phone number to which the ZyXEL Device 
forwards all incoming calls.

voice config forward busy <index> <phone-

number> 

Specifies the phone number to which the ZyXEL Device 
forwards incoming calls when the phone port is busy.

voice config forward noanswer <index> 

<phone-number> 

Specifies the phone number to which the ZyXEL Device 
forwards incoming calls when the call goes unanswered 
for a period of time you specify in the  voice config 
forward noanstime 

command.

voice config forward noanstime <index> 

<seconds> 

Sets the amount of time the ZyXEL Device waits before it 
considers a call unanswered.