ZyXEL Communications n/a Manual Do Utilizador

DSL & IAD CLI Reference Guide

Use these commands to configure the ZyXEL Device’s WAN settings.

Use these commands to configure the ZyXEL Device’s ADSL interface settings.

The following example:

• Resets the ADSL modem.

• Displays the firmware version.

Table 61   wan adsl Commands

wan adsl chandata

Shows the ADSL channel data and line rate.

wan adsl close

Closes the ADSL line.

wan adsl coinfo

Displays information on the current modem status.

wan adsl fwversion

Displays the current DSL firmware version.

wan adsl linedata far

Shows ADSL far end noise margin and carrier load 
information.

wan adsl linedata near

Shows ADSL near end noise margin and carrier 
load information.

wan adsl open

Opens the ADSL line.

wan adsl opencmd 

<adsl2|adsl2+|gdmt|multimode>

Opens the ADSL line with the specified standard.

wan adsl opmode

Shows the ADSL operational mode (standard). 

wan adsl perfdata

Shows performance information such as the CRC, 
FEC, error seconds.

wan adsl rateadap <on|off>

Activates or deactivates rate adaption.

wan adsl reset

Resets the ADSL modem to the saved 
configuration. 

wan adsl status

Displays ADSL status (up, down or initializing). 

wan adsl targetnoise 

<target_noise_margin>

Sets the target noise margin.

:  -31 ~ 32.

wan adsl version

Displays the ADSL firmware version.