ZyXEL Communications n/a Manual Do Utilizador

DSL & IAD CLI Reference Guide

Use these commands to configure DECT (Digitally Enhanced Cordless Telecommunications) 
settings on the ZyXEL Device. 

These commands are only available on ZyXEL Devices which have a DECT cordless phone 
base station. 

The following section lists the commands for this feature. 

Table 23   dect Command Summary

voice config dect index <index>

Loads the DECT settings for configuration.

voice config dect bspassword 

<index> <base-station-password>

Sets the base station password. This is the password that DECT 
phones must enter when registering with the base station. 

: 4 digit number, for example “0987”.

voice config dect save <index>

Saves the DECT configuration on the ZyXEL Device.

voice config dect display <index>

Shows the base station password.

: 1 

voice dect page

Pages all handset registered with the base station on the ZyXEL 
Device.

voice dect reset

Resets the base station and initiates it.

voice dect handsetlist

Displays the list of registered handsets.

voice dect version

Displays the base station firmware version.

voice dect upgradefw

Upgrades the base station firmware via a console. The DECT 
upgrade should only be performed by a service technician. 

voice dect subscript

Enables DECT subscription to allow DECT phones to register with 
the base station.

voice dect restoredectrom

Resets the DECT module to the factory defaults.

voice dect fwupgrade

Upgrades the base station firmware via a console. The DECT 
upgrade should only be performed by a service technician. 

voice dect clearhandset

Removes the list of registered handsets.

voice dect fwversion

Displays the base station firmware version.