ZyXEL Communications n/a Manual Do Utilizador

DSL & IAD CLI Reference Guide

Use these commands to configure IP settings on the ZyXEL Device.

The following table describes input values for some of the ip commands. Other values are 
discussed with the corresponding commands.

The following section lists the IP commands.

Table 29   IP Command Input Values

An IP address in dotted decimal notation. For example, 192.168.1.3. 

A protocol’s port number.

An interface on the ZyXEL Device. enif refers to an Ethernet interface.

enif0

: LAN

enif1

: WAN 

enif2

: DMZ

wanif0

: PPPoE or PPPoA

For some commands you can also add a colon and a 0 or 1 to specify an IP alias. 
This is only for the LAN and DMZ WLAN interfaces. For example, enif0:0 
specifies LAN IP alias 1 and enif0:1 specifies LAN IP alias 2.

A domain name.

The number of bits in an address’s subnet mask. To find the bit number, convert 
the subnet mask to binary and add all of the 1’s together. Take “255.255.255.0” for 
example. 255 converts to eight 1’s in binary. There are three 255’s, so add three 
eights together and you get the bit number (24).

The number of system report records to display. For example, if you specify 10, 
the top 10 report entries display.

Table 30   IP Commands

ip arp status [interface]

Displays an interface’s ARP table.

ip des test

Performs the DES/3DES hardware chip testing and 
displays the result. 

ip des reset

Resets the DES/3DES hardware chip.

ip dhcp <interface> client 

release

Releases the specified interface’s DHCP IP address. The 
interface must be a DHCP client to use this command.

ip dhcp <interface> client 

renew

Renews the specified interface’s DHCP IP address. The 
interface must be a DHCP client to use this command.