Ariens 991085 Manual Do Utilizador
GB - 10
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
required.
1. Unpack Unit - Remove shrink wrap and
packaging materials.
2. Remove Unit From Container - Open
Bypass Valves (dump valves) (See
Moving the Unit with the Engine Off on
page 16).
Push unit from container onto a level
surface. Close the bypass valves.
Moving the Unit with the Engine Off on
page 16).
Push unit from container onto a level
surface. Close the bypass valves.
3. Tires - See Specifications on page 31.
4. Seat - See Seat Adjustments on
5. Position Steering Levers - Remove
eccentric spacers and rotate steering
levers to the operating position. Reinstall
spacers. Tighten hardware securely.
See Aligning the Steering Levers
(Figure 14) on page 23.
levers to the operating position. Reinstall
spacers. Tighten hardware securely.
See Aligning the Steering Levers
(Figure 14) on page 23.
6. Battery - Remove battery from unit and
7. Check Engine Crankcase - Check and
add oil if needed. See Engine Manual for
specifications.
specifications.
8. Fill Engine Fuel Tank - Fill fuel tank. DO
NOT OVERFILL! See Filling Fuel Tank
on page 14.
on page 14.
NOTE: See engine manual for fuel type.
9. Hardware - Check for loose hardware.
ASSEMBLY
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
Read and understand entire
Safety section before proceeding.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
separation of tire and rim parts is
possible when they are serviced
incorrectly:
•
Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
tire without the proper
equipment and experience
to perform the job.
•
Do not inflate the tires
above the recommended
pressure.
above the recommended
pressure.
•
Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
•
Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
1. Steering
Levers
2. Seat
3. Mounting
Hardware
OF4110
Figure 3