Vermont Casting ICVCTK01 Manual Do Utilizador

3

1.  Read all instructions before using this appliance.
2.  This appliance is hot when in use. To avoid burns, do not 

let bare skin touch hot surfaces. If provided, use handles 
when moving this appliance. Keep combustible materials, 
such as furniture, pillows, bedding, papers, clothes and 
curtains away at least 3’ (914 mm) from the front of this 
appliance.

3.  CAUTION: Extreme caution is necessary when any 

4.  If possible, always unplug this appliance when not in use.
5.  Do not operate any heater with a damaged cord or plug 

or after the appliance malfunctions, has been dropped or 
damaged in any manner.

6.  Any repairs to this appliance should be carried out by a 

qualified service person.

7.  Under no circumstances should this appliance be modi-

fied. Parts having to be removed for servicing must be 
replaced prior to operating this fireplace again.

8.  Do not use outdoors.
9.  This heater is not intended for use in bathrooms, laun-

dry areas and similar indoor locations. Never locate this 
appliance where it may fall into a bathtub or other water 
container.

10. Do not run cord under carpeting. Do not cover cord with 

throw rugs, runners or the like. Arrange cord away from 
traffic areas and where it will not be tripped over.

11. To disconnect this appliance, turn controls to the off posi-

tion, then remove plug from outlet.

12. Connect to properly grounded outlets only.

When choosing a location for your new fireplace, en-
sure the general instructions are followed. Also, for best 
effect, install the fireplace out of direct sunlight.

 

Sides (including trim assembly) ........... 0” (0 mm)

 

Bottom ........................................... 9⁷⁄₈” (250 mm)

 

Top ....................................................3’ (914 mm)

13. This appliance, when installed must be electrically 

grounded in accordance with local codes, with the current 
CSA C22.1 Canadian Electrical codes or for US installa-
tions, follow local codes and the National Electric Code, 
ANSI/NFPA No. 70.

14. Do not insert or allow foreign objects to enter any venti-

lation or exhaust opening as this may cause an electric 
shock, fire or damage the appliance.

15. To prevent possible fire, do not block air intakes or ex-

haust in any manner. Do not use on soft surfaces, like a 
bed, where openings may become blocked.

16. This appliance has hot and arcing or sparking parts inside. 

Do not use it in areas where gasoline, paint or flammable 
liquids are used or stored. This appliance should not be 
used as a drying rack for clothing, nor should Christmas 
stockings or decorations be hung on or near it.

17. Use this appliance only as described in this manual. Any 

other use not recommended by the manufacturer may 
cause fire, electric shock or injury to persons.

18. Avoid the use of an extension cord because of the risk of 

overheating the cord and the risk of fire. Extension cords 
are for temporary use only. If an extension cord must be 
used, it must be UL/CSA certified, rated at 15A (1875W), 
125 V maximum with 14 AWG minimum and constructed 
of two current carrying conductors with ground. A heavy 
duty extension cord with the shortest length possible for 
this connection is recommended and must not be longer 
than 50 ft. (15.2 m). Do not coil or cover the extension 
cord.

Unit: EFHI4S0