Emerson Process Management 3410 Manual Do Utilizador
Reference, Installation, and Operations Manual
Section 3: Installation
3-9000-743 Rev S
June 2013
Transducer assembly security seal installation
91
3.6.3
Transducer assembly security seal installation
Use the following instructions to install the security seal wires on the Transducer Assembly (
for transducer removal instructions).
Figure 3-29 Transducer housing, cable nut and security seal
1.
Check the installation of the following parts:
•
Transducer Housing - securely tightened and flush with the meter body
•
Transducer cable nut - snugly tightened and flush with Transducer Housing
2.
For each Transducer Assembly, install a security seal wire (maximum wire diameter 0.09
inch; 2.3mm) on the Transducer Cable Connector to the Transducer Cable Nut by
rotating the Transducer Cable Nut clockwise; compressing the seal on the Transducer
Cable Connector (
rotating the Transducer Cable Nut clockwise; compressing the seal on the Transducer
Cable Connector (
).
3.
Twist and adjust wire removing all slack and seal. Remove excess wire (
A.
B.
B.
C.
A. Transducer cable nut
B. Transducer cable chordset
C. Security wire seal
B. Transducer cable chordset
C. Security wire seal