Crane EE-3184-4138 Manual Do Utilizador
7. The Power Light will turn on red. In a few seconds it will switch to green, indicating
that enough water is in the water basin, and mist will start emitting through the
openings at water tank lid.
8. Use the humidity output regulator control knob to adjust
the intensity of the mist output. Turning the knob
clockwise will increase the moisture output, turning the
clockwise will increase the moisture output, turning the
knob counterclockwise will reduce the moisture output.
(see Fig. 10)
(see Fig. 10)
Note: When at maximum level it is normal to hear a faint
dripping sound.
dripping sound.
Fig. 10
9. When the humidifier runs out of water the power light will turn red, and the mist
output will stop. This is a safety feature to prevent the humidifier from possibly over
heating and damaging the nebulizer. This safety feature uses a water level sensor to
heating and damaging the nebulizer. This safety feature uses a water level sensor to
stop the nebulizer once the water level sinks below the required level in the water
basin. Turn the humidifier off and unplug before removing and refilling the water
basin. Turn the humidifier off and unplug before removing and refilling the water
tank. Please note that the power light on the humidifier body will stay on.
The (red) light signal indicates that the humidifier is turned on and needs to
be refilled.
The (red) light signal indicates that the humidifier is turned on and needs to
be refilled.
INSERTING HUMIDIFIER FILTER
(SOLD SEPARATELY not included with your humidifier)
A humidifier filter is an optional accessory for your Crane Cool Mist Humidifier.
Filters are used to eliminate white dust caused by hard water and to reduce
Filters are used to eliminate white dust caused by hard water and to reduce
mold spores and bacteria that can build up in your humidifier.
Place humidifier filter in humidifier as shown in Fig. 10A
NOTE: Do not leave filter in humidifier longer than
recommended time. See filter instructions on filter box
recommended time. See filter instructions on filter box
packaging.
Filters are not included with the humidifier and can be
purchased separately.
purchased separately.
Fig. 10 A
SET THE CORRECT HUMIDITY OUTPUT
Adjust the mist control so that the mist
rises up and gets absorbed by the room
air. Do not turn on too high an output
as the mist cannot be absorbed by the
air. Do not turn on too high an output
as the mist cannot be absorbed by the
air and accumulates on the surface
around the humidifier.
around the humidifier.
If the humidifier is placed near a fan or
air conditioning outlet the mist may be
air conditioning outlet the mist may be
forced down by the foreign air stream.
Change the location of the humidifier or
Change the location of the humidifier or
reduce the output of the other room
conditioning appliances.
conditioning appliances.
correct
wrong
7