Gemini GEM-P800 Manual Do Utilizador

Your Installer has assigned a User 1 Code which can be used to not only Arm and Disarm the system,  but also  to enter the User
Program Mode, where you can program other user codes.  The following explains how you will use this code to program or erase
additional user codes.

Press 

followed by 

and enter the User 1 code folowed by

.

  The Armed, Status and 

lights will flash, and the 

keypad will  beep 4 times. You are now in the User Program  mode.  Zones 1 through 8 will light to indicate any User Codes 
presently programmed.

Press the User number to be programmed. (For example, press 

to program the User 2 code.).

The keypad will beep 2 times and the  corresponding Zone  will flash to indicate the user number you are about  to program.

Press in the 4 digits of  the new User 2 code, the keypad will beep 4 times.

If  there are more user codes to be programmed, return to step 1 above, otherwise, go to Exiting the User Program Mode 
below.

Press the User number to be erased. The keypad will beep 2 times and the corresponding Zone light will flash to indicate the 
user number you are about to erase.

Press

.  The zone light will go out to indicate that the user code has been erased.

If there are more user codes to be erased, return to step 1 above, otherwise, go to Exiting the User Program Mode below.

When you are done programming or erasing User codes, press 

to Exit the User Program Mode.

 14

Oi219c 
page 14

Tuesday, September 16, 1997 08:24