Gemini GEM-P800 Manual Do Utilizador

1

Before arming your system, make sure the green Status light is ON. This indicates that all of your protective zones are 
secure. If any zones are open,  the corresponding Zone number will be lit. Secure these zones before proceeding. If any 
zones cannot be secured,  see Bypassing zones below.

2 

Enter your user code and  press

.

  The green Status light will go out,  the red Armed light will light.

• 

If you make a mistake entering your code, press 

, re-enter the code and press

.

• 

If FIRE

is lit, the Fire zone has not been properly reset.  Press

, enter your user code and press 

.

(See Silencing a Fire Alarm, page 8)

3 

Leave the premises through the Exit/Entry door.  If  the keypad gives a steady tone you have taken too long. Enter your code 

  again to disarm system and then re-enter code and leave.

 

The optional Easy Arm feature allows the system to be armed by simply pressing

.

 This will allow  the easy arming of  the 

system by  someone who is not a regular system user.

If an open zone cannot be immediately fixed it can be left unprotected, or 

bypassed ,while the rest of  the system is Armed.

To bypass a zone:

1

Press

followed by the number of the zone to be bypassed. The bypassed zone’s number will flash slowly.

2 

Enter your user code and press

.

  The green Status  light will go out and the red Armed light will light.

3 

Leave the premises through the Exit/Entry door.

When the system is subsequently disarmed, all bypassed zones will be reset,  ready to be armed again. If it is necessary to 
bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as possible.
A  bypassed zone does not provide any protection, compromising  system security.

 5

Oi219c 
page 5

Tuesday, September 16, 1997 08:24