Hitachi DZ-GX5080A Manual Do Utilizador

English

1<>2/3

You can use the LED light to illuminate a subject to be recorded in a dark place.

Press the e button during recording pause or recording.
An icon will appear on the screen, and the LED light will glow.

Press the e button again.
The LED light will go out.

• Pressing e will turn the LED light on and off 

alternately.

• The LED light will go out if you perform the following:

- Display the Disc Navigation screen
- Start playback
- Switch to demonstration mode

• Recording with LED light on will shorten the battery 

life more than recording with LED light off.

• Do not turn the LED light on with your eyes near it. 

Also, be sure not to look directly into the light emitting 
portion when the LED light is on: Doing so could 
cause visual disorder, such as decreased sight. And 
especially: Do not record small children at close-up 
distance with the LED light turned on.

• Do not use the LED light while pointing at a driver in 

vehicle: Doing so could dazzle the driver, causing an 
accident.

• Do not use the LED light in a place where there is 

flammable or explosive gas: Doing so could cause fire 
or explosion.

• Do not block the light emitting portion when the LED 

light is turned on: Doing so could generate heat.

• Do not display the LED light beam reflected on a 

mirror, etc. on TV screen: Doing so could cause 
burning of screen.

• Once you press the e button to turn the LED light 

on, it will remain on until the e button is pressed 
again, which is different from the conventional flash.

• When using the LED light for recording, set the 

distance to subject at no more than 4.9 feet (1.5 m).

8 : 0 0 A M

2 / 1 0 / 2 0 0 7

3 0 MIN

0 : 0 0 : 0 0

FINE

REM

LED light icon

LED light