Hotpoint WDPG 8640 Manual Do Utilizador

unevenness by tightening or loosening the 

adjustable front feet (see figure); the angle 

of inclination, measured according to the 

worktop, must not exceed 2°.

Levelling your appliance correctly will provide 

it with stability and avoid any vibrations, noise 

and shifting during operation. If it is placed on 

a fitted or loose carpet, adjust the feet in such 

a way as to allow enough room for ventilation 

beneath the washer-dryer.

1. Connect the supply 

pipe by screwing it to 

a cold water tap using 

a 3/4 gas threaded 

connection (see 

Before performing the 

connection, allow the 

water to run freely until 

it is perfectly clear.

2. Connect the other 

end of the water inlet 

hose to the washer-

dryer, screwing it onto 

the appliance’s cold 

water inlet, situated 

on the top right-hand 

side on the rear of the 

appliance (see figure).

3. Make sure there are no kinks or bends in the 

hose.

! The water pressure at the tap must be within 

the values indicated in the Technical details 

table (on the page 5).

! If the water inlet hose is not long enough, 

contact a specialist store or an authorised 

serviceman.

! Ensure that the supply taps are allowing 

water through. Old taps may seize in the 

closed position and thus prevent water 

reaching the machine.

! Never use second-hand or old inlet hoses; 

use the products supplied with the machine.

! Keep this instruction manual in a safe place 

for future reference. Should the appliance 

be sold, transferred or moved, make sure 

the instruction manual accompanies the 

washer-dryer to inform the new owner as to its 

operation and features.

! Read these instructions carefully: they contain 

vital information on installation, use and safety.

! This is a separate 

part of the polystyrene 

base and should be 

removed with the 

base.

! IMPORTANT check 

when unpacking 

your machine.

1. Unpack the washer-dryer.

2. Check whether the washer-dryer has been 

damaged during transport. If this is the case, 

do not install it and contact your retailer.

3. Remove the 4 

protective screws and 

the rubber bush with 

the respective spacer, 

situated on the rear of 

the appliance (see also 

the installation leaflet).

4. Seal the gaps 

using the plastic plugs 

provided.

5. Keep all the parts: 

you will need them again if the washer-dryer 

needs to be moved to another location.

! Packaging materials are not children’s toys.

Your machine may make a considerable 

amount of noise if the two front feet have not 

been adjusted correctly.

1. Install the washer-

dryer on a flat sturdy 

floor, without resting 

it up against walls, 

cabinets or anything 

else.

2. If the floor is 

not perfectly level, 

compensate for any