Roland RS 232C Manual Do Utilizador
r
AR-3000 RS-232C Reference
-
8
= PL (PLay)
Function: Playback start
Syntax:
Syntax:
stxPL;
Note:
If the playback phrase has not been specified, the minimum default value
(normally A001) will be used. The phrases specified by the PA command will be
played back consecutively.
(normally A001) will be used. The phrases specified by the PA command will be
played back consecutively.
* If Dual Mono Mode is ON
Since phrases will be played back from the L or the R output depending on whether
they are odd or even numbered phrases, phrases specified by the PA command will
automatically be assigned to the playback memory; odd-numbered phrases will be
played back from the L output, and even-numbered phrases will be played back from
the R output. It is not possible to playback the L and R channels independently.
they are odd or even numbered phrases, phrases specified by the PA command will
automatically be assigned to the playback memory; odd-numbered phrases will be
played back from the L output, and even-numbered phrases will be played back from
the R output. It is not possible to playback the L and R channels independently.
= RL ( Relative time pLay )
Function: Playback from the Middle of a Phrase
Syntax:
Syntax:
stxRL: * , **H**M**S**F ;
stxRL: * , **H**M**S ;
stxRL: * , **H**M**S ;
a
b
a Locate Forward / Backward
b Offset Time
0 Backward
0H0M0S0F – 11H59M59S
1 Forward
0H0M0S0F – 11H59M59S**F
Example) stxRL:1,0H10M59S0F;
- After specifying a phrase: Playback begins 10 minutes 59 seconds from the beginning
of the phrase of the specified number.
- While playback is paused: Playback begins from the point that is 10 minutes 59
seconds after the point where the pause was initiated.
of the phrase of the specified number.
- While playback is paused: Playback begins from the point that is 10 minutes 59
seconds after the point where the pause was initiated.
Note:
The number of digits for **F (frame) increases according to the value of MTC type.
The range in which the offset time can be specified is valid only within a single phrase.
An offset time that exceeds the recording time for the phrase cannot be specified.
(The AR-3000 outputs an ER command.) You can play back a phrase from a point offset
by a specified time before or after a paused point by sending this command while
playback is paused (see the PE command).
The range in which the offset time can be specified is valid only within a single phrase.
An offset time that exceeds the recording time for the phrase cannot be specified.
(The AR-3000 outputs an ER command.) You can play back a phrase from a point offset
by a specified time before or after a paused point by sending this command while
playback is paused (see the PE command).
* When “Return Specified” is issued with an offset time longer than elapsed time:
The phrase is played back from the beginning.
* When “Forward Specified” is issued with an offset time longer than the remaining
time: An ER command is output and playback is not carried out. (The paused state
remains in effect, so specify a new offset time and send an RL command again.)
remains in effect, so specify a new offset time and send an RL command again.)
Caution: The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
= ST (STop)
Function: Halting playback/recording
Syntax:
Syntax:
stxST;