Niles Audio LZR510 Manual Do Utilizador

I

N T E L L I

P

A D

®

C i

T

O U C H

S

C R E E N

K

E Y P A D

For a new construction site, use our optional New Construction Bracket (FG01060) to provide a
support for mounting the TS-1 on new drywall, as shown in Figure 14.

Using the optional New Construction Bracket (FG01060) to install a TS-1 in new construction.

I

N T E L L I

P

A D

®

C i

T

O U C H

S

C R E E N

K

E Y P A D

1. At a proposed site, use the enclosed wall template to mark the outline of the TS-1. Check for

hidden obstructions by drilling a small hole in the drywall at the center of the outline. If you
feel any obstructions while drilling, stop immediately and select another site.

2. Bend a piece of stiff wire (e.g., coat hanger) about 6 inches from the end at a 90-degree angle.

Insert the bent end into the hole and rotate the wire to check if there are any other obstruc-
tions. If you hit anything, patch the hole with drywall compound and choose another site.

3. Connect the CAT-5 cable(s) to the TS-1’s rear jack(s) (see Connecting the TS-1 on page 27).

IMPORTANT: Test cable prior to connection, miswired and damaged cables can cause dam-
age to the TS-1.

4. The TS-1 is equipped with two Mounting Clamps for easy installation. Hold the TS-1 firmly in

the opening and use a Phillips screwdriver to turn each mounting-clamp screw to the right
until the TS-1 feels fastened, as shown in Figure 13.

Using the TS-1’s built-in mounting clamps.