3com 09-1632-000 Manual Do Utilizador
Configuration Procedure
19
2 Add the phone number of the other site (Office B) to the
dial number list.
a In the Dial on Demand Dynamic Dial section of the
navigation frame, click the PORT DialNoList link.
b In the start field, choose 4.
c In the DialNoList field, enter the phone number in
quotes of the remote site in the DialNoList field. For
example, enter:
example, enter:
"4085551212" T=BRI B=64
d Click Apply.
If you wish to use both BRI channels on this port, you
must specify a second phone number in the dial number
list.
must specify a second phone number in the dial number
list.
e In the start field, choose 4.
f In the DialNoList field, enter the second phone number
in quotes of the remote site. For example, enter:
"4085551212." T=BRI B=64
The “.” in the phone number entry above allows you to
enter the same number in both places.
enter the same number in both places.
g Click Apply.
3 Set the port to dial on demand.
a In the Dial on Demand Dynamic Dial section of the
navigation frame, click the PORT DialInitState link.
b In the start field, choose 4.
c In the DialInitState field, choose DialOnDemand.
d Click Apply.
4 Enable multilink protocol control on the port.
a In the Dial on Demand Dynamic Dial section of the
navigation frame, click the PPP MlpCONTrol link.
b In the start field, choose 4.
c In the MlpCONTrol field, choose Enabled.
d Click Apply.
OC10.book Page 19 Thursday, May 13, 1999 2:33 PM