Flying Pig Systems FireBallTM FP-1 Manual Do Utilizador
PAGE 76
FireBall™ FP-1 User
’s Manual
addItIonaL InForMatIon
sPEcificAtioNs
Specifications are subject to change without notice. Please check the
Escient web site for any changes to the specifications.
Video Specifications
• NTSC
• 10 bit Video DACs
• Frequency Response:
• Composite: -2 dB @ 5MHz
• S-Video: -2 dB @ 5MHz
• SNR: 50 dB
• Crosstalk: 50 dB
• Input Impedance: 75Ohm
• Output Impedance: 75Ohm
audio Specifications
• Frequency Response: 2 – 20,000 Hz, ±1 dB
• THD+N (playback) < -80 dB FS A (< 0.01%)
• A_D-DSP-D-A Dynamic Range: > 96 dB FS A @ 1kHz
• Channel Separation: >95 dB
• Full Scale Line Output: >2 Vrms, 50 k ohms
• S/PDIF Output: 0.4Vpp to 0.6Vpp, <0.05Vdc (75ohm terminated)
• Power Requirements: AC 100-240VAC, 50-60 Hz
• Power Consumption: < 18 watts
Physical Specifications
Width: ~ 17 3/8”
Height: ~ 4 5/8” w/ feet; ~ 4” w/o feet
Depth: ~ 11 7/8”; Installed 14 3/8”
3rd Party certifcations
• FCC: US Part 15, Class B
• NTSC Video Output: NTSC RS-170A
• cETL Listing
• Conforms to: UL STD 6500-2000
• Certified to:
CAN/CSA STD E60065-00
• CE
Fcc Part 15, Subpart B
Class B
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.
• Shielded cables must be used with this unit to ensure compliance
with the Class B FCC limits.