ONKYO DV-SP506 Manual Do Utilizador

 

15

 

A

OPTICAL DIGITAL AUDIO OUTPUT [21, 22]

 

This optical digital audio output can be connected to 
an optical digital audio input on a hi-fi amp, AV 
receiver, or surround sound decoder (Dolby Digital, 
DTS).

 

B

COAXIAL DIGITAL AUDIO OUTPUT [21, 22]

 

This coaxial digital audio output can be connected 
to a coaxial digital audio input on a hi-fi amp, AV 
receiver, or surround sound decoder (Dolby Digital, 
DTS) with supplied coaxial digital cable.

 

C

 

This HDMI jack outputs digital video and audio and 
can be connected to an HDMI input on a compatible 
TV or other component.

 

D

S VIDEO OUTPUT [22, 23]

 

This connector can be used to connect a TV or pro-
jector with an S-Video input.

 

E

VIDEO OUTPUT [22, 23]

 

This RCA connector can be used to connect a TV or 
projector with a composite video input.

 

F

COMPONENT VIDEO OUTPUT [22, 23]

 

These jacks output component video and can be 
connected to an component video input on a TV or 
projector.

 

G

 

This port is for servicing.

 

H

 

These 

 (Remote Interactive) connectors can be 

connected to the 

 connectors on your other 

Onkyo AV components for interactive control.
Connecting an 

 cable only does not make the 

system operational. You must also connect the audio 
cables as well.
If you’re using RIHD, do not connect anything to 
these connectors.

 

I

 

These jacks make up the multichannel analog audio 
output. The D.MIX/FRONT jacks can be connected 
to a stereo input on a TV, hi-fi amp, or other compo-
nent. The 1 and 2 jacks output the same signals, so 
use either pair. If you use this connection, in the 
Speaker Configuration (page 52), set the Sub-
woofer, Center Speaker, and Surround Speaker set-
tings to Off, so that 5.1-channel DVD audio is down 
mixed into two channels.
If you’re using an AV receiver or surround decoder 
with a 5.1-channel analog audio input, use the 
D.MIX/FRONT 2 jacks and the SURR 1 L/R, CEN-
TER, and SUBWOOFER jacks.
If you’re using an AV receiver or surround decoder 
with a 7.1-channel analog audio input, connect the 
SURR 2 L/R jacks to the surround back L/R input 
jacks on your AV receiver or decoder, and set the 
SURR MODE switch to “1+2.” The SURR 1 and 
SURR 2 jacks output the same signals.

 

J

 

This switch is used to turn the AUDIO OUTPUT 
SURR 2 on or off. To use this output, set the switch 
to “1+2.” The SURR 2 jacks output the same signals 
as the SURR 1 jacks.

 

K

 

The supplied power cord is connected here. The 
other of the power cord should be connected to a 
suitable wall outlet.

 

L

 

This SCART output can be connected to a TV or 
projector with a SCART input. This SCART con-
nector outputs 2-channel stereo audio (same signals 
as the D.MIX/FRONT jacks), composite video, 
S-Video, and RGB video.

DV-SP506_En.book Page 15 Friday, September 5, 2008 3:23 PM