Invacare 1335 Folheto
1
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Non-Folding Device
Model No. 1335
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe and proper installation and adjustment of the Non-Folding Device,
these instructions MUST
these instructions MUST
be followed:
WARNING
DO NOT use this equipment without first reading and understanding this instruction
sheet and the owner’s manual supplied with the product. If you are unable to
understand the warnings, cautions and instructions, contact a healthcare professional,
dealer or technical personnel if applicable, before attempting to install this equipment
- otherwise, injury or damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
After any adjustments, repair or service and before use, make sure all attaching
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
DO NOT overtighten the attaching hardware when securing the non-folding device to
DO NOT overtighten the attaching hardware when securing the non-folding device to
the wheelchair frame, otherwise damage to the hardware and/or wheelchair frame
may occur.
The non-folding device kit contains the following items:
NOTE: If the non-folding device will not fit on the wheelchair, contact an Invacare Dealer.
NOTE: The non-folding device is not designed to narrow the width of the wheelchair.
NOTE: The non-folding device is not designed to narrow the width of the wheelchair.
Installing the Non-Folding Device
NOTE: For this procedure, refer to FIGURE 1.
1. Remove the locknut and the hex head bolt from the clamps at both ends of the
1. Remove the locknut and the hex head bolt from the clamps at both ends of the
non-folding device.
2. Loosen, but DO NOT remove the locknut on the lug bolt on the adjustment clamp.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
DESCRIPTION
QUANTITY
Lug Bolt
1
Locknut
3
Non-Folding Device
1
Hex Head Bolt
2
Plastic Insert Guide
2