LOEWE 32959022 Manual Do Utilizador

- 4

Various options for managing stations are available via the TV menu. For

example the description for TV stations. For radio stations the same applies,

except that the radio menu is called in radio mode (see also page 6).
➠

Station management is not possible if a programmed timer recording

is still pending.

In the search/update with the search wizard, new stations are searched

for which are not yet stored.

➠  

You have to repeat the initial installation (see page 11)

and automatically search for new ones if you want to

delete all the existing stations and automatically search

for new ones. Do also use the first installation if you

want to change to receiving MHEG-5 stations (attend

restrictions for DVB software update, see page 5).

Call TV menu.

34 Select Settings,

 6 go to the menu line below.

34 Select Stations,

 6 go to the menu line below.

34 Select Search wizard,

 6 go to the menu line below.

In the upper info text the current search settings will now

be displayed:

If you want to change these search settings:

34

Select Change search settings,

 OK wizard prompts search settings.
If you agree with these settings:

34

Select Start search/update,

 OK start search.

Red button: Abort current search/update.

Select  the  country  for  country-specific  defaults  and
station sorting.

Select  antenna,  cable,  or  satellite  here,  depending  on
where you want to search for new stations.
At  this  point  you  can  also  call  a  configuration  of  the
DVB-T  and  DVB-S  antennae  via  the  green  button  (see
page 1).

With  selection  of  set  location  the  conventional  TV
standard/colour standard is the default. This should only
be  changed  if  stations  with  other  standards  are  to  be
searched.

You can state whether coded stations are to be searched
for in the search/update.

Select yes then coded stations

are also searched for. However, these stations can only
be received in connection with a CA module and the ap-
propriate Smart Card.

Ask your dealer which Smart Card

you need to receive certain stations. Handling of the CA
module is described on page 4.

If you want to run the station search independently of
the channel grid, select frequency search for the search
method.

With the selection of set location the conventional set-
tings will be preset. Only change this if you know other
symbol  rates  and  modulation  types  or  if  you  have  to
specify the network ID for your cable network (informa-
tion available from your cable network provider).
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.

The symbol rate is specified by the satellite provider and
normally does not need to be changed.

Set location

Signal source

TV/colour

standard

Encrypted

stations

Search method

Settings

Symbol rate

Start search/update

Change search settings

Search wizard

TV menu

Settings

Stations

Search wizard

Your TV carries out the update of the station range (search for new stations;

delete stations no longer broadcast) with the following settings:

Location of TV set                 

United Kingdom

Signal source                     

DVB-T

END

OK